S&S Cycle Stealth Air Cleaners for S&S X-Wedge Engines - Manual (Page 2)

1. Apply supplied thread locker to 1/16-27 pipe plug #50-8332, and
install it in unused hole in backing plate. See Picture 1.
2. For Muscle cover kits, remove the lanyards from the supplied
gasket by squeezing the rivets on the small end with a pair of
pliers as illustrated in Picture 2. This gasket will not be needed for
the installation on an S&S® X-Wedge® engine.
3. Apply the supplied thread locker to the 10-24 x 1/4" panhead
screw and attach lanyards # 500-0095 to the back plate as shown.
Lanyards must be attached to the outer surface of the back plate.
See Picture 3.
4. Thread the three 1/4-20 x .825" socket button head screws #500-
0059 through the back plate as shown in Picture 4.
5. Install back plate mounting tabs #170-0202 loosely as shown in
Picture 5 with 1/4-20 x .500" socket head screws #106-2084. These
screws have a thread lock patch, so thread locker is not needed.
Do not final tighten.
6. Trim off unneeded portion of back plate gasket #106-6022 as
shown in Picture 6. Only the three back plate mounting bold
holes are required. Place back plate gasket over screws in back
plate. Apply thread locker to the exposed threads. Picture 7.
Picture 1
Picture 5
Picture 4
Picture 6
Picture 2
Picture 3
2