Salsbury Industries 93000 Series Plastic Lockers (93168,93368 Triple Tier) User Manual
Page 3
Plastic Lockers – 93000 Series
Models 93168 & 93368 Triple Tier
Assembly Instructions
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
www.lockers.com engineering
@
lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2012 Salsbury Industries. All rights reserved. 1/3/12 Page 3 of 3
Step 11. Slide the shelves (optional) into the slots in the locker side
panels. There are three (3) slots available for shelves in each of the
compartments.
Step 12. Install the sloping hood (optional) to the top of each locker
column by aligning six (6) locating tabs with the topmost panel.
Press locating tabs into place. Illustration shows sloping hood before
pressing tabs into place. Plastic filler strips shown in step 6 are not
required on units with a sloping hood and can be discarded.
Step 13. Install placards (optional) in the indentation near the top of
each door.
Step 14. If two (2) or more lockers are to be installed side by side,
the lockers should be fastened together with the four (4) nuts and
long screws provided. Select any two (2) holes toward the front and
any two (2) holes toward the rear. The illustration below shows the
12 holes that are available. The lower illustration shows the inside
view of a hole and screw.
The assembly of the plastic lockers is now complete.
SLOPING
HOOD
INSIDE VIEW
OF HOLE
AND SCREW
SHELF