SPYPOINT IR-7 - Manual (Page 5)

8 9
English
English
SETTINGS
Date, Time, Temperature and Picture Quality
Turn « OFF » your camera; set switch « MODE » to « SET/
TEST » and turn « ON » the camera. Press « MENU/OK ».
An « H » will flash on the screen indicating that the camera
is in High Resolution (7 MP). Use the « DOWN » button
if you want to reduce the resolution to « L » (3 MP). Press
« MENU/OK » to set the date and time (mm/dd/yy, hh/mm).
Use « UP » and « DOWN » to change the blinking digit. Choose
« F » or « C » to display the temperature in Fahrenheit (°F) or
Celsius (°C). Press « MENU/OK » to go to the next option.
Once finished, press « MENU/OK » and turn « OFF » the
system to save the changes.
MODE
When the « PHOTO » or « VIDEO » mode is selected, the
test light in the front of the camera flashes for 60 seconds to
allow the user to leave without being photographed or filmed.
When the « SET/TEST » mode is selected, no picture or video
is recorded. Walk perpendicularly in front of the camera. When
the camera detects movement, the light winks to indicate that
normally, a photo or video would be recorded. If the system does
not detect the movement, increase the distance detection using the
wheel
« DISTANCE » or realign the system differently. When you
understand how the device responds to detections, you can better
adjust the direction or the height of the installation.
When the
switch is set to « VIEW », you can view the recorded pictures
or videos on television.
DELAY
To select the time interval before the camera records another
photo or video.
Additional setting: it is possible to decrease the delay between
detections to 10 seconds (instead of 1 minute) by using the
following procedure. Note that the battery life will be
affected.
10_5
10 sec. delay 1 min. delay
Turn OFF the camera. Press and hold the « UP » button, turn
the camera on. « 10_S » appears on the screen meaning the
1 minute delay has been replaced by a 10 second delay. To
reset the camera to 1 minute delay, follow the same procedure.
« 1_M » appears on the screen (see figure below).
MULTI-SHOT
To take up to 4 consecutive shots at each detection, with a 10
second delay between each photo. This option is available in
« PHOTO » mode.
VIDEO LENGTH
Allows you to select the recording duration when the camera is
set in « VIDEO » mode.
DISTANCE
Turn the dial to the right to increase distance.
The « DISTANCE » dial (placed on the side of the camera) can
adjust the sensitivity of the detector. The camera is equipped
with a detector sensitive to infrared. The system detects only heat
source in motion. The greater the mass of heat, more sensitive is the
system.
Range of detector is between 5 and 50 feet. The best way
to adjust the distance is to set the camera in « SET/TEST » mode
(see above). Make sure to have the least possible objects in front of
the camera during the positioning. This prevents picture taken by
the camera when oriented towards the sun while an object moves in
front of the camera (eg. a branch)