SPYPOINT HD-10 - Manual (Page 4)

6 7
English
English
POWER
The battery level is shown in the bottom right corner of the
screen when the camera is in « TEST » mode. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The use
of alkaline or lithium batteries is strongly recommended. Also
note that the voltage of rechargeable AA batteries (1.2V)
is insufficient to power your SPYPOINT camera. During
the installation of AA batteries, place the switch inside the
battery case to «ALKALINE». Insert the batteries as indicated
inside the battery case. Exact polarity must be followed. We
also recommend the use of new batteries to ensure maximum
performance of your camera.
Lithium battery pack
The camera SPYPOINT HD-10 can be powered by a
rechargeable lithium battery LIT-09/LIT-C-8 (sold separately,
refer to the section «OPTIONS»). This type of battery is less
affected by cold temperatures and lasts up to 3 times more then an
alkaline battery. During the installation of lithium battery, place
the switch inside the battery case to «RECHARGEABLE».
External (12V)
The camera can be powered from an external 12 volt DC
input such as a 12 volt battery (KIT-12V/BATT-12V, sold
separately) or a 12 volt adapter (AD-12V, sold separately).
When using a 12 volt connection, we recommend removing the
AA batteries to prevent surcharges.
During the installation of a
12 volt connection, place the switch inside the battery case to
«ALKALINE» . If combined with a lithium battery pack, slide
the switch to «RECHARGEABLE» . To find the accessories
available for the 12 volts, refer to the section «OPTIONS».
Solar panel
This model also offers the possibility of a connection to
a solar panel SP-12V (sold separately, refer to the section
«OPTIONS») to maintain the charge of the lithium
battery (sold separately, refer to the section «OPTIONS»)
or the 12 volt battery (sold separately, refer to the section
«OPTIONS»). During the installation of the rechargeable
lithium battery or 12 volt battery, slide up the switch inside
the battery case up to «RECHARGEABLE» to activate the
charging system of the solar panel.
MEMORY CARD
Using a memory card (sold separately, refer to the section
«OPTIONS») is required to operate the camera SPYPOINT
HD-10. When the camera is «ON» and no memory card is used,
the screen displays « Insert memory card ». The SD slot of
the camera has a 32 GB memory capacity. Before inserting or
removing the memory card, the camera must be turned «OFF».
Failing to do so may cause loss of or damage the pictures
already recorded from the memory card. When the SD card is
full, the viewing screen indicates « Disk Full ». The following
data shows an approximate quantity of photos or video length
that can be taken by the camera depending on the memory card
capacity.
RESOLUTION 2.0 GB 4.0 GB 8.0 GB 32 GB
5 MP
6 MP
8 MP
10 MP
12 MP
1900
1580
1190
950
790
3800
3160
2380
1900
1580
7600
6320
4760
3800
3160
30400
25280
19040
15200
12640
VIDEO RESOLUTION
640 x 480
1280 x 720 (720p)
65 min
40 min
2h10
1h20
4h10
2h40
16h40
10h40
« BUSY » LED
The « BUSY » light, located next to the screen, lights up when
the camera is recording.