Keypad lock (optional on most models), Operation of specific models, Keypad lock – Summit CM411LPLUSADA User Manual
Page 12: Optional on most models)
Factory-set default password: The factory-set default password is 0123. If the default
password is lost, press the
key (located inside the battery
box) for 30 seconds, then wait for the warning sound which
signifies the factory-set default password has been restored.
To set the password: While door is open, press the
key
(located inside the battery box) until it jingles, enter the 0123
password, then # within 10 seconds to confirm. Enter the
password (1-16 digits), then press # again to confirm. A total
of 10 passwords can be set.
Note: Each password starts with a number from 0 to 9 in order. The first password
starting with 0 is the default password. For example, use 1xxx, then 2xxx etc.
for 10 users.
Changing password: While the door is open, press the
key (located inside
the battery box) until it jingles, enter the old password and press # within 10
seconds to confirm. Enter the new password, then press # to confirm.
Note: The first digit cannot be changed.
To open the door: While the door is closed, press the
key, enter the
password, then press
again to confirm.
To lock door manually: Press #.
Function setting of automatic lock: Setting of the auto-lock time: Press the
key (inside the battery box), enter a number (any number between 10-99),
then press # to confirm. The auto-lock time can be set between 10-99 seconds
after opening the door. If the time is set less than 10 seconds, the door will not lock
automatically, only manually.
Deleting the door-opening passwords: Press the
key, enter default
password followed by 0000, then press # and all the door-opening passwords will
be deleted except for the default password.
Note: To access the battery box you need to remove only the two small screws on
the top and bottom of that cover. Do not remove the 4 screws holding the
keypad and cover to the appliance door.
KEYPAD LOCK
(Optional on most models)
OPERATION OF SPECIFIC MODELS
SCFF55LPLUS Series
These are built-in, frost-free units that do not require defrosting. At the top of the
unit is a cooling system that uses a fan to provide cold air. For best operation,
do not block the air flow with contents. The thermostat is located at the top right
of the unit.
Felix Storch, Inc.
Page 12