Summit FF73 - Manual (Page 7)

6
Reversing the Door Swing:
Your refrigerator is built with a reversible door. You have the choice of either opening it
from the left or the right side. In order to reverse the opening direction of your door,
please follow these simple instructions:
1. Disassemble all the reversible components in the sequence as shown below (also
refer to left diagram above). Be sure to keep them available for later use in the
process of reassembling.
(1) leveling leg II (10) door, freezer section
(2) leveling leg I (11) top hinge
(3) 2 screws to hold bottom hinge (12) 2 screws to hold top hinge
(4) bottom door baffle block (13) cover to top hinge
(5) bottom hinge (14) 1 screw to hold cover of top hinge
(6) door, refrigerator section (15) upper door left stopper
(7) mid hinge
(8) 2 screws to hold mid hinge
(9) upper door right stopper
2. To access the bottom hinge assembly, you may tilt back the refrigerator cabinet or
lay the refrigerator on its back.
3. Remove the upper door right stopper (9), install the upper door left stopper (15) on
the opposite side; take down the bottom door baffle block (4), and install it on the
opposite side.
4. Reassemble the unit with the door hinges on the opposite side (see the right
diagram above). The sequence for reassembling is just in reverse order of
disassembling.
5. With the mid hinge not being fastened too tight, align the two doors properly on the
cabinet and then fasten the mid hinge. If necessary, loosen the bottom hinge and
the top hinge when aligning and then fasten them tight.