Summit DW2432SS Installation Manual - Manual (Page 8)

6. ENCLOSURE PREPARATION
Notice:
For proper dishwasher operation and appearance, ensure that the enclosure has the minimum
dimensions shown in the figure on the previous page.
6.1 ELECTRICAL PREPARATIONS
WARNING
To avoid electrical shock and/or a fire hazard, make sure electrical work is properly installed. Only
qualified electricians should perform electrical work.
Before installation, disconnect the power supply to the work area by unplugging the unit, “tripping”
the circuit breaker or removing the fuse.
The installer has the responsibility of ensuring that the dishwasher electrical installation is in
compliance with all national and local electrical codes and ordinances. The dishwasher is
designed for an electrical supply of 120 V, 60 Hz, AC, connected to a dishwasher-dedicated,
properly grounded electrical circuit with a fuse or breaker rated for 15 amperes.
WARNING
Electrical supply cords must be a minimum of #14 AWG copper
wire.
Position the cable extending approximately 30” (760mm) from the
enclosure’s back (Figure A).
To the right side, position the cable extending
approximately 5½” (140mm) (Figure B).
Remove 2-15/16” – 3-15/16” (75mm – 100mm) of the
cable’s outer casing, and then remove ⅜” – ½” (9mm –
13mm) of insulation from each wire (Figure C).
6