Regency Horizon HZ33CE Small Gas Fireplace - Manual (Page 49)

Regency HZ33CE Gas Fireplace
49
INSTALLATION
If installing the optional mantel ensure the combustible and
non combustible material around the unit are installed fl ush
with the unit. (See Diagram 1 below).
The mantel cannot be installed if materials are not fl ush.
1. Install 2 middle screws on unit face - do not tighten. Slide
bracket over screws then tighten, install 2 outer screws .
2. Install four (4) wood screws, two (2) on each side of the
bracket into the wall studs as shown below.
Diagram 1- Materials fl ush w/unit.
Diagram 2 -Bracket screw locations on unit.
Diagram 3 -Bracket screw locations into stud.
Diagram 6 -Final Install
5. Lift up mantel and line up the middle rib on backside of faceplate with
middle indent on bracket. This will centre the faceplate and allow 1/16"
adjustment from side to side.
4. Line up fl ange on hearth portion of mantel, with opening between bracket
and unit.
3. Repeat steps 1 and 2 to install lower bracket - screw locations are shown
below.
Install middle 2 screws on
to unit fi rst
OPTIONAL MANTEL INSTALLATION
Combustible
Material
Non-combustible Material (3-1/2" x 36")
Nailing Strip -1/2" back from unit face
Combustible
Material