Regency Panorama P33 Small Gas Fireplace - Manual (Page 54)

54
Regency ® P33-4 Zero Clearance Direct Vent Gas Fireplace
MAINTENANCE
THERMOPILE/
THERMOCOUPLE
1) Open the bottom louvers.
2) Loosen the thermocouple or thermopile with a
7/16" wrench.
3) Disconnect thermocouple by loosening nut
from the valve with a 9mm wrench. Disconnect
thermopile by loosening 2 screws marked TP
on the valve.
4) Drop the thermocouple or thermopile down from
the bracket and pull it out of the unit.
5) Reinstall the new ones in reverse order.
GLASS GASKET
If the glass gasket requires replacement use 5/8"
fl at glass gasket for the Bay Front (Part # 936-243)
and a tadpole glass gasket for the Flush Front (Part
# 936-155).
DOOR GLASS
Your Regency ® fi replace is supplied with high
temperature, 5 mm Neoceram ceramic glass that will
withstand the highest heat that your unit will produce.
If your glass requires cleaning, we recommend
using an approved glass cleaner available at all
authorized dealers. Do not use abrasive materials.
Do not clean the glass when hot.
In the event that you break your glass by impact,
purchase your replacement from an authorized
Regency
® dealer only, and follow our step-by-step
instructions for replacement.
WARNING: Do not operate the ap
Remove the fl ush door front. Remove the 4 glass
clips from each corner. Slide in the new replacement
glass. Push the 4 glass clips back onto the frame.
The glass must have gasketing around it.
Bay Glass Replacement
1) Remove the door from the unit and place on
a soft surface to prevent scratching.
2) Remove the nuts holding the glass clips in
place and remove.
3) Replace the glass. The glass must have
gasketing around it.
5) Reverse the previous steps, replace the glass
clips and fasten with the nuts but do not over
tighten, as this can break the glass.
6) Replace door on the Fireplace and check the
seal.
Caution: Wear gloves when removing
damaged or broken glass.
Flush Glass Replacement
pliance with the glass panels
removed, cracked or broken.
Replacement of the glass panels
should be done by a licensed or
qualifi ed service person.