Regency Panorama P36E Medium Gas Fireplace - Manual (Page 62)

P36E-4 Zero Clearance Direct Vent Gas Fireplace 62
Note: The facing material has to go on after
the unit is set.
1) Remove Glass Door. Refer to P36E
Manual.
2) Remove 2 screws and bracket as indicated
(refer to Diagram 3).
3) Install On/Off switch (refer to Diagram 4).
4) Place bracket under the Flange. Secure
with 2 screws as indicated in Diagram 5.
5) Loosen the 3 x #8 Phillips Head Screws lo-
cated on the inside top of the outer frame of
the appliance (refer to Diagram 6).
Diagram 3
Remove
bracket
Remove both
screws
Diagram 4
On/Off
Switch
Control
Mounting
Bracket
Diagram 5
3 x #8
Phillips
Diagram 6
Note: The Nailing Strips can be adjusted,
depending on the facing material (as indicated
in Diagram 8).
9) Optional
Install Optional 3-Panel Arch Door. (Refer
to Install 3-Panel Arch Door Instruction
Sheet).
10) Change in Logo
Replace existing logo with Regency logo.
8) Attach Top and Side Support Frame
a) Ensure the Side Supports are aligned with
the corresponding hole on the Top Support
Frame, then secure with 1 screw.
b) Repeat step on the other side.
Diagram 8
1/2”
Facing
Material
1” Facing Material
6) Install Top Support Frame
Slide in the Top Support Frame using the
slots as a guide. Secure and re-tighten the
screws to the unit.
View of backside of Top Support
Frame.
Cut-Outs
a) Mount Side Support Frame to unit as
shown in Diagram 7, then secure with 2
screws on each side.
b) Repeat step on the other side.
7) Side Support Frame
Diagram 7
REGENCY ® OPTIONS