Talos Security BC1080VIR56 HD-SDI - Manual (Page 2)

Camera setting Camera installation
[PIC 2]
[PIC 1]
Camera setting
Extra Video output
for preview
Joystick Push
Menu / Enter
1. Open the front cover for adjustment of desired viewing angle and it can be
controlled by using the Focus/Zoom control stick like as [PIC 2]
2. According to [PIC 2], open the front cover to SETUP the OSD menu by using
Joystick.
3. If necessary, change OSD setting for desired
performance, at camera control panel
* The extra video output can be used for installation with
the Portable monitor.( For the camera setting, please check the OSD menu)
* Push the OSD joystick little more than 1sec., OSD manu will be appeared.
* Move the OSD joystick to change the setting.
* Push the OSD joystick to Enter and Set the menu.
4. After changing OSD menu, lock the front cover completely for weatherproof.
N
∞
T W
UP
DOWN
RIGHT LEFT
Cover
“L”wrench
Video Jack
(BNC/RCA)
1. On the ceiling(or wall), make the Anchor hole and put the Anchor into
the hole completely.
Use Fixing Screw to settle (Anchor size : Φ4 / Length 30mm)
2. After set up the Bracket Base, use “L”wrench to make tight the Camera Body
and Bracket Head
Mountbase
Conduit hole Cap
Anchor
1
1 1 2
2
3
3 Axis Bracket Guard
Fixing Screw
Open
Camera setting
Open
Open
Open
Close
Close
Close
Hood Fixing Screw
How to assemble the hood How to assemble camera base and Mount Base
Camera
Camera Base
DC 12V
Power Jack
Power (+)
Power (-)
Video Signal
Video GND
Cable Jack Setting
Video Jack Power Jack
(DC 12V)