TerraWave TW-HC-1142A User Manual
Page 3
TerraWave Solutions
®
802.11n MIMO 18”x 18” x 1.5” Hard Cap Ceiling Enclosure
Installation Instructions
Version 2.0
www.terrawave.com Email: [email protected] Phone: 210-375-8482 or 800-851-4965 10521 Gulfdale, San Antonio, TX 78216
For detailed product information and to purchase product, please contact a TerraWave
wireless networking solutions sales engineer at 210-375-8482, 800-851-4965,
[email protected] or visit
www.terrawave.com
.
Installing the Enclosure Housing in the Ceiling or Wall (continued)
5. Locate the studs or other obstacles within the ceiling or wall. Do not mount enclosure where obstacles will
prevent enclosure sitting flush with the wall surface.
6. Cut the ceiling or wall surface to accept the enclosure housing. It is not recommended to cut the hole larger than
13” x 13”. If installing using the toggle bolts, pre-drill the holes to mount the enclosure. A 1” bit is recommended.
(Figure 4).
7.
7. Feed power and Ethernet connections through the cord grip in the back of the enclosure (Figure 5).
8. Secure the enclosure to the surface by using the included toggle bolts or wood screws (Figure 6).
TerraWave is the primary manufacturer in the
industry to offer such cutting-edge products
for wireless networking deployments.
Figure 4
Figure 5
Figure 6