Therasage Instant Calmer Easy Start Up Guide - Manual

Therasage, L.L.C. 21000 Boca Rio Road, Suite A-21C Boca Raton, Florida
www.Therasage.com
Instant Calmer Healing Pad Instructions
Easy Start-Up
 Place the Pad on a flat surface with jade side facing up
 Plug the controller into the pad with arrows facing up
 Plug the electrical plug into the electrical socket (standard 110v)
 You will see a “5” on the controller – this is the temperature default
setting (medium heat)
 The up and down arrows allow you to adjust the heat setting from “1”
to “9”
 Hit the Green Mode Button
 You will see a “60” reading on the controller – this is the default time
setting
 The up down arrows allow you to adjust the time from 15 minutes to
90 minutes
 Press Orange ON/OFF button to turn on the heat once you have
adjusted settings to your comfort
 Green light indicates the Pad is on
 The time will appear once the heat is activated and the timer will
countdown until the end of the cycle
 When the cycle is complete, the last temperature setting will be
displayed
 To reset for the same cycle (same heat and same timing), hit the
Orange ON/OFF button
 To change settings, follow directions above
 While the heat is activated, the temperature can be changed during
the session by using the up and down arrows
 The time CANNOT be adjusted in the middle of a cycle (while the heat
is activated)
 During the session, you may notice the green light above the ON/OFF
button will begin to blink. This is just an indication that the pad has
reached the desired temperature.
 If a “00” appears at any time, UNPLUG the controller from the wall,
and UNPLUG the connection from the pad. Then re-plug into the pad
(making sure the connection is secure) and then plug back into the
wall.