Titus Displacment Ventilation - Manual (Page 22)

DVIR Installation
Installation Manual
DV 5-9-13
Step 1
Screw the Plenum-Inlet Assembly into
place through the sides. (Note: Plenum-
Inlet Assembly is mounted before the wall
board is fixed)
Step 2
Install the Mounting frame-Distributor
assembly to the wall board using screws.
Step 3
Install front cover onto the Mounting
frame-Distributor assembly.
Commissioning (Balancing)
Uninstall the front cover for
commissioning. The balancing port is
positioned on the lower edge of the unit.
The K-factor of the unit is stated on K-
factor label placed on one of the side of
the Plenum box. The k-factor can also be
found on our website in the relevant k-
factor guide. See Figure 4
FIGURE 4
FIGURE 2
7.0