Traditions Tip Up User Manual
Page 24
24
interfere with the safe and reliable function of the
firearm.
7. Before firing remove all excess lubricant from the
bore.
!
WARNING
: DO NOT ATTEMPT TO
DISSASSEMBLE RECEIVER. THIS INCLUDES ANY
PINS HOLDING THE RECEIVER TOGETHER.
CLEAN AS A UNIT. Any attempt to do so will void the
factory warranty & may cause the firearm to be unsafe
& may result in injury and/or death.
XIII: RE-ASSEMBLY
1. Insert the barrel by sliding downward and
forward until the monoblock meets the pin.
2. Using one hand to support the barrel and the
other to support the frame/stock, pivot the barrel
in an upward motion to close the action.
3. With the barrel attached and the action closed
re-insert the forearm. With the nose of the
forend pointing down insert the rear part of the
forend against the frame and pivot up until it
meets the screw post.
4. Use Hex wrench to draw screw into screw post
and tighten.
5. With the firearm reassembled, make sure to do a
thorough function check of the rifle. At this time