Traditions Turkey Pro Shotgun - Manual (Page 14)

88
4. Remove bolt spring and spring follower.
5. Squeeze trigger and slide bolt handle back
to the rearmost position in the receiver. see
fig. 2
6. Remove bolt handle by pulling straight out
from side of the receiver. You may have to
jiggle the handle a bit while pulling.
7. Squeeze the trigger and push the bolt out through the rear of receiver.
By pulling trigger, it allows the sear to drop down and allow the bolt
to be removed. You should have 5 parts on the table
IGNITION
Note: Breech plugs and nipples will wear out over time and
should be replaced periodically. We recommend that you
purchase at least one extra nipple and breech plug for
emergencies in the field or at the range. Thread size of
standard Traditions nipples is M6x1. Thread size of Magnum
Traditions nipple is M8x1.
Removal of the Nipple or 209 adapter:
1. Make sure that the nipple is not capped or primed.
2. Remove the bolt assembly from the receiver.
3. Insert the breech plug wrench supplied with your muzzleloader
through the rear of the receiver (while squeezing the trigger) and
position the correct side of it over the nipple.
4. Insert the handle into the wrench and unscrew the nipple
counterclockwise.
Removal of the Breech Plug:
1. Insert the larger end of the wrench into the receiver (while squeezing
the trigger) and position it onto the breech
plug.
2. Insert the rod handle into the wrench.
3. Turn the wrench counter-clockwise and
unscrew the breech plug and withdraw the
wrench and plug from the receiver. It may
require some extra force to free up the
breech plug after shooting.
Fig. 2
Fig. 11
Fig. 10