TruXedo Lo Pro QT - Manual (Page 2)

Inside Bulkhead
Side Rail
Header Seal On
Top Of Bulkhead
Approx 8”
LOWER CLAMP
Passenger’s
Side Rail
Header Guide
Bracket
Spring Plunger
Safety Straps
STEP 1: Attach the TruXedo rails to the truck’s vertical inside flange as
shown in Detail A. To get the correct TruXedo rail alignment
from front to back, See Detail-B. Compress the rear D-seal
against the closed tailgate and hold. Attach clamps starting at
the tailgate. Evenly space 3 clamps along each TruXedo rail,
leaving approximately 8” on each end.
STEP 2: For optimum latching performance and cover fit, side rails
must be level. To adjust rails, loosen screws and reposition
male clamps higher or lower. Tighten all clamps.
STEP 4: Push header guides into place under side rail. A click sound
will indicate a secure attachment. See detail D & E below.
STEP 3: Set cover assembly behind cab with header seal on top of of
bulkhead. See detail C.
SIDE RAIL & COVER INSTALLATION
Driver’s
Side Rail
Cover
Assembly
Rubber
Seal
End
Plug
OUTWARD TILT
Truck’s Vertical
Inside Flange
FRONT OF
TRUCK BOX
Bottom
View
FRONT OF
TRUCK BOX
CLAMP
ASSEMBLY
TENSION
CONTROL
Cover Assembly
T
ruck
B
ox
F
ronT
Side Rail
Tighten clamps securely on side
rails before driving vehicle.
WARNING !
Clamp
Assembly
CORRECT RAISE CLAMP
LEVEL INWARD TILT
NOTE: Clamp configurations shown are for reference only and
are not intended to be standard for all pickups.
D
eTail
-a
Height
Flush
See Step 2 For Correct
Clamp Height.
D
eTail
-B
3/16” Compress
D-Seal
Closed Tailgate
CLICK CLICK
Header Guide
N
otice
DetAiL “c”
Header Guide Retainer
DETAIL “E” DETAIL “D”