UVP Rocker Tray 76-0053-01 - Manual

Installation Instructions
81-0210-01 Rev B
UVP, Inc. 2066 W. 11th Street
Upland, CA 91786
(800) 452-6788 / (909) 946-3197
Fax: (909) 946-3597 / E-Mail: [email protected]
Ultra-Violet Product Ltd., Trinity Hall Farm Estate
Unit 1, Nuffield Rd, Cambridge CB1 1TG UK
+44(0)1223-420022 / Fax: +44(0)1223-420561
E-Mail: [email protected]
Rocker Tray 76-0053-01
Internet: www.uvp.com
Installing the Rocker Tray P/N 76-0053-01
To install the Rocker Tray in the HB-1000 or HL-2000,
remove the metal bottle carousel from the chamber.
1. Place the tray into the chamber with the coupling
arm positioned on the right side.
2. Lift the coupling arm and slide the three pins into the
pin hub located on the right side wall of the chamber.
Note that the pin lengths are different and can be
placed in any position in the pin hub.
3. Slide the tray towards the right so that the pin mount
slides against the hub.
Coupling Arm
Pin Mount and Pins
Tray Placement Hub Location Pin Mount Placement
Pin Hub
1.
2. 2.
3.
Operating the Rocker Tray
After installing the Rocker Tray, to operate the tray
press the “Motor Control” ON button on the control panel.
Adjust the RPM speed from MIN to MAX as required for
your experiment.
Control Panel