Vigo VG06051 - Manual (Page 10)

7
TOP VIEW
INSIDE OF THE SHOWER
3 3
3
FIG. 10
FIG. 11
11
7
MODEL VG06051
3
10
E. INSTALLING THE DOOR
1. Remove the rollers (#3) from the box, note that these are fully installed. Carefully unthread
the cap with a small head allen key. You will see a big hex screw, this is referred to as the
roller height adjustment screw.
2. Use the provided allen key to unscrew the adjustment screw and dismantle the roller. Place
the screw through door panel top holes and attach the two top rollers onto the door panel
(#7). [SEE FIG.10]
3. Place the two top rollers and the door panel (#7) assembly onto the structural rail (#16).
Note that the rollers have a built-in mechanism that will provide adjustment for walls that are
not 100% perpendicular to the floor. If necessary, unscrew the adjustment screw and rotate
the individual roller. This will raise or lower the height that the roller sits on the structural rail.
Please refer to pages 14-17 for "Roller Adjustments to Accommodate Out of Square
Openings." Once the rollers are properly adjusted and the door sits straight in the closed
position, the adjustment will be complete.
4. Align the door guide (#11) onto the door. Hold the door in the vertical-level position. Mark
the location of the bottom door guide on the floor.
5. Remove the door from the structural rail. Mark holes on the floor for the mounting screws.
Drill the holes and place plastic anchors (#25) inside them.
6. Screw the door guide to the floor with 1-1/8" screws (#21).
7. Place the door back on the structural rail. Screw the bottom rollers (#3) to the door. [SEE
FIG.11]
8. Adjust the stoppers' position on the structural rail and tighten the hex screws.