Vigo VG06042B User Manual
Page 9
9
MODEL VG06042
DOOR PANEL
OUTSIDE HANDLE
INSIDE HANDLE
SCREW
METAL WASHER
CLEAR WASHER
WHITE TUBE
GLASS SUPPORT
METAL WASHER
F. INSTALLING THE STRUCTURAL ARM
G. INSTALLING THE HANDLE
1.
Unscrew the handle holders from the handle assembly (#8).
2.
Place the handle to to position on the door. Place plastic washers (supplied) on each side of the
door. [SEE FIG. 8]
3.
Tighten the handle nuts from inside the shower.
H. INSTALLING SEAL STRIPS
1. Install the door side seal strip (#12) to the door when the door edge towards the wall is away from
the turning hinge base (#1). If maximum length of the shower enclosure is required and the door
edge is within rubbing distance of the glass support install the side seal strip without bump (#9) . [SEE
FIG. 9]
2. Install the door bottom seal strip (#10) onto the bottom of the door panel.
3. Install the magnetic seal strips (#19) onto the door panel and the side panel. Note: F-shaped seal
strip (#23) may be installed to the door panel at this point if customers choose not to install the side
panel due to space constraints. Right threshold clip with screw hole (#25) should not be installed in
this case either.
WALL
FIG.7
FIG.8
FIG.7A
1.
Attach the structural arm (#30) to the top turning hinge base (#1).Note that the structural arm has
an adjustable screw hole of 1/2" length. This will allow for flexibility and proper install placement
[SEE FIG. 7 & 7A].
2.
Mark two holes on determined locations on the wall for the mounting screws and insert plastic
anchors (#16) into them.
3.
Resecure the structural arm to the turning hinge base and tighten the screw (supplied)
connecting the turning hinge base and the structural arm.
4.
Screw the structural arm making sure it is firm and plum to the wall with 1
5/8 " phillips screws
(#14) and push screw covers into place.
1/2" tolerance adjustment
THREADED SCREW
14
30
16
See Fig. 7A