Vortex Optics SHOOTING STAND - Manual

Connecting to scope or camera
The stand offers a standard ¼" 20 mount screw that works
with any camera or spotting scope. Simply thread the mount
screw into the mounting foot of your scope/camera, then
tighten your equipment to the stand with the lock on the
stand mount screw.
Making Stand Adjustments
To pan from left to right, release the tension on the pan knob.
To tilt up and down, release the tension on the tilt knob. If you
wish to make fine tilt adjustments, use the micro-adjustment
knob directly below the mount block of the stand. Adjust the
height of the center column by releasing the pan knob. Lock
the center column to the desired height by setting the center
column lock on the pan/center column knob.
One-Year Limited Warranty
Your shooting stand is warranted to be free of defects in
materials and workmanship for one year after the date of
purchase. Vortex Optics will repair or replace such product or
part thereof that upon our inspection is found to be defective
in materials or workmanship. This warranty does not cover
defects caused by misuse or improper handling, installation,
or maintenance of the product.
If warranty problems arise, or if you need assistance in using
your tripod, please contact:
Vortex Optics
2120 West Greenview Drive
Middleton, WI 53562
800-426-0048
[email protected]
Congratulations
The Vortex Shooting Stand is the perfect portable mount for
any spotting scope or camera, and was designed to be rugged
enough to handle all outdoor uses.
Set-up and use
The stand comes ready to use out of the box, simply attach the
scope or camera and it’s ready to be used.
Vortex Optics
Shooting Stand
A. Mount screw
B. Tilt course adjustment knob
C. Tilt fine-adjustment knob
D. Pan/center column knob
E. Center column lock
© Vortex Optics USA