Waring Pro TG15 - Manual (Page 4)

6 7
HOW TO ASSEMBLE CONTAINERS WITH
REMOVABLE BLADES
Always wash and rinse container prior to initial use.
1. Before starting, make sure that the
blender cord is unplugged and that the
switch is in the OFF position.
2. Refer to Figure 1. The following points
are important to note when putting
together the container assembly:
• Container gasket must be placed
between blade assembly and
container.
• Collar must be threaded properly
onto the blender container base, and
securely tightened before placing food
or liquid in the container.
• To ensure proper assembly, place the
blender container upside down and
turn the collar counterclockwise until securely tightened.
3. Place assembled blender jar on unit base so that it is firmly
seated and not tilted to one side. Never place the collar or
blade assembly on the unit base unless the container has been
completely assembled and securely tightened.
HOW TO DISASSEMBLE & CLEAN CONTAINERS
WITH REMOVABLE BLADES
Always wash and rinse container immediately after use.
1. Be sure the switch is in the OFF position.
2. Remove the container assembly from the unit base and empty
the contents.
3. To disassemble the Waring Pro ® Tailgater ™ Blender, turn
container collar clockwise.
4. The collar, blade assembly and gasket are dishwasher safe.
The plastic container lid and insert must be washed by hand.
Allow all parts to air dry.
5. Be certain all components are in the proper position when
reassembling blender container and base.
HOW TO CLEAN UNIT BASE
To clean the unit base, unplug the power cord. Wipe the exterior
surfaces with a soft cloth or sponge dampened with cleaning
solution. Rinse with clean water. Do not immerse the base in
cleaning solution or water. Wipe the base with dry towel.
FUSE REPLACEMENT
The plug on the blender power cord contains a replaceable
cartridge fuse. To gain access to the fuse, push the metal tip of the
plug inward as far as it will go, then turn it counterclockwise until
it releases. Withdraw the tip, with the fuse attached, by pulling it
straight out of the plug body. Replace fuse with one of same size
and rating (15 Amperes, 32 Volts, Slow-Blow). Reassemble plug
by reversing above procedure.
Any other servicing should be performed by an authorized service
representative.