WarmlyYours Environ II Floor Heating System - Manual (Page 16)

16
7. The heater should be used strictly in accordance with the following:
a) Hard wire the unit into a 110 Volt ~ properly sized circuit. If a single thermostat controls several mats, please make sure the thermostat’s
amperage and the circuit’s amperage are appropriate for the total electrical load of the mats.
b) Should you feel no warmth on the carpet or laminate fl oor within 30 minutes, verify that there is power coming to the control or thermostat.
Contact WarmlyYours.com after verifying that there is power at the plug point. Under no circumstances tamper with or attempt to repair
the heater – this will render the warranty null and void.
c) Use reasonable care in the operation of the heater. Do not drop heavy articles on the carpet, or pierce the carpet with sharp objects.
d) Turn off the heater when shampooing carpets or if any spillage occurs to eliminate undue shrinkage. Do not turn on again until carpet,
underlay and heater are all dry.
e) To prevent possible overheating or discoloration of the carpet, do not cover the heated carpet for long periods with articles like foam
mattresses, sleeper couches, pillows, etc.
f) All restrictions and instructions in this installation manual must be complied with. If they are not complied with the warranty is void.
Environ II is a trademark of WarmlyYours.com Inc., this Environ II electric radiant fl oor heating panel is manufactured by Warmup
Heating Systems, Inc. in South Africa, and distributed exclusively by WarmlyYours.com in North America, Canada and Mexico.
WarmlyYours.com Inc
2 Corporate Dr.
Lake Zurich IL 60047
Ph. (
800) 875.5285
Fax. ( 800) 408.1100
Email: [email protected]
Website: www.WarmlyYours.com
LIMITED WARRANTY continued
20003-F
9/2011