WarmlyYours Lava LED - Manual (Page 3)

Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
13. Make a mark at the “scissor” icon that is closest to the desired “end” location but do NOT cut the LED strip at
this time. This is the tentative ending point of the strip.
14. Use a marker to note folding locations on the front of the LED strip.
15. Using a marker or piece of tape, mark the location of the LED strip “START” point on back of the LAVA.
16. Remove the tape pieces temporarily securing the LED strip to the back of the LAVA.
17. Locate the mark on the LAVA that was made to indicate the “Beginning” of the LED strip.
18. Begin to peel back the LED strip’s paper backing at the “Beginning” end of the LED strip. The backing of the
LED strip has a pressure-sensitive adhesive surface. Push the led strip firmly to the back of the lava.
19. Remove the paper backing to expose enough of the LED strip to make the bend in the lower right corner.
This should be visible by the mark previously made on the front of the strip indicating the first corner fold.
20. Repeat STEP 18 for attaching the LED strip to the right, top and left sides of the LAVA.
21. After attaching the LED strip in the lower left corner, route the strip WITHOUT removing the paper backing
along the lower edge of the LAVA to see where the nearest or pre-marked “scissor” icon comes to rest in relation
to the “beginning” of the strip. SEE STEP 11 CONCERNING LED COVERAGE AT OVERLAP.
22. Once the cut point of the LED strip has been determined and double-checked, cut the strip with scissors at
the chosen “scissor” icon.
23. Remove the paper backing from the LED strip and push the strip firmly to the rear of the LAVA unit to attach
the final section of the strip.
24. Long-term testing has proven the ability of the LED adhesive to stay firmly attached to the rear LAVA
surface. For added peace-of-mind, a high quality tape (3M Scotch Tape, or similar) can be used in each corner of
the LAVA and at the “Beginning” and “END” of the run for extra support. See illustration.
BACKING
START
POINT
TAPE