Waterpik WP-900 Quick Start - Manual

3 4
1 2
Replace Remove
High
Pause
High
Low
NO
Gap
NO
Gap
Insert
Lift the hinged reservoir lid and remove the
reservoir from base and fill with lukewarm water.
Replace the reservoir onto the base,
PRESSING DOWN FIRMLY to ensure
full seating. There should be no gap
between the reservoir and the base.
For first time
users, adjust
pressure control
to lowest position .
Gradually increase
pressure to your liking.
Prior to Very First Use of Unit, Prime Unit:
Set pressure control dial on base to high, point
the handle and tip into sink. Turn unit ON until
water flows from the tip, turn unit OFF.
You can temporarily stop
water flow by pressing
the pause button on
the handle.
continued on back
Press tip firmly into
handle. When tip is
properly inserted there
should be no gap
between handle and
colored tip ring.
This device is only compatible with a voltage system of 120VAC, 60Hz. Do not plug this device into a voltage system that is different.
Select and Insert Tip: Prepare the Reservoir:
Prime Unit (First Time Use Only): Adjust Pressure and Pause Control:
QUICK START GUIDE
Model WP-900