Western Digital WD Black2 Dual Drive User Manual - Manual (Page 12)

WD Black² Dual Drive
User Manual
CLONING YOUR EXISTING HARD DRIVE – 10
8. Disconnect the SATA to USB adapter cable from the computer and the new dual
drive.
9. Remove the notebook battery.
10. Remove the system cover or open the notebook/remove the hard drive PC cover
panel (refer to your computer manual for instructions) and carefully remove the
hard drive from its slot (Step 04). If applicable, remove the old hard drive from the
bracket.
11. If applicable, attach the new dual drive to the bracket. Insert the dual drive into
the slot. Close the hard drive cover (Step 04).
12. Replace the battery (if applicable) and power on your computer.
13. Run the WD Black² Installation Software that you downloaded in step number 2
to activate and partition the HDD (Step 05). See “WD Black² Installation
Software” on page 11 for details.
14. If needed, attach the original HDD using the SATA to USB cable and transfer
(copy/paste) any remaining user data from your original HDD to your new WD
dual drive (Step 06).
15. Your computer should automatically recognize the new dual drive. You may now
re-enable the secure boot feature if you disabled it in step 1.