Bissell STEAM & SWEEP 46B4 - Manual (Page 5)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
Your Steam & Sweep assembles
quickly and easily. The only tool you
will need for assembly is a Phillips
head screwdriver.
Your Steam & Sweep is packaged with
the following items:
Handle Assembly
Lower Body with Water Purification
System
Maneuverable Swivel Head
Removable Water Tank
1 large Phillips Head Screw
1 small Phillips Head Screw
2 Mop Pads
Attach handle to Steam & Sweep
1. Attach lower body to maneuverable
swivel head (If your Steam & Sweep
came with the swivel head already
assembled to the body, you may skip
this step).
2. Secure maneuverable swivel head with
small Phillips head screw. Tighten until
secure.
3. Slide handle assembly down into lower
body until it will go no further.
4. Secure the handle by placing the large
Phillips head screw through the screw
opening in the lower body and into the
rear of the handle assembly. Tighten with
screwdriver until secure.
5. Slide water tank onto lower body by
lining up vertical glides and gently
sliding tank into place.
Steam & Sweep assembly is now complete.
1.
3.
5.
4.
2.
5