Western Digital WD VelociRaptor User Manual - Manual (Page 3)

-1-
Congratulations on purchasing a WD VelociRaptor! This document was designed to
aid in the quick installation of your new SATA hard drive. If you experience problems
following these procedures or need further information regarding the installation and
use of your drive, visit our website at http://support.wdc.com to search our online
knowledge base for frequently asked questions and other common troubleshooting
tips.
Compatibility
Windows ® 7, Windows Vista ® , Windows XP
Note: Compatibility may vary depending on your
hardware configuration and operating system.
System Requirements
• SATA interface connector on motherboard, or
SATA controller card (sold separately) installed in
an available 32-bit PCI expansion slot (2.1- or
2.2-compliant).
• 3.5-inch internal drive bay.
Unpacking & Drive Handling
WD hard drives are precision instruments and
should be handled with care during unpacking and
installation. Hard drives can be damaged by rough
handling, shock and vibration, or electrostatic
discharge (ESD). Be aware of the following
precautions:
• This product contains no user-serviceable parts;
refer servicing to WD-authorized personnel only.
• Do not unpack your hard drive until you are ready
to install it. Your hard drive is packaged in an anti-
static bag.
• To avoid ESD problems, ground yourself by
touching the metal chassis of the computer before
handling the hard drive. Articles of clothing
generate static electricity. Do not allow clothing to
come in direct contact with the hard drive or
circuit board components.
• Handle the hard drive by its sides only. Avoid
touching the circuit board components on the
bottom of the hard drive.
• Do not drop, shake, or knock down the hard drive.
• Do not stack hard drives or stand your WD hard
drive on its edge.
Getting Started
1. Gather these materials and tools: WD hard drive
kit; computer system manual; operating system
manual and DVD or CD; SATA host controller
drivers (if applicable);Phillips and flat-blade
screwdrivers.
2. Before performing any hardware installation, back
up your existing data.
3. Before handling the hard drive or any other
components, discharge static electricity by
touching the metal chassis of your computer or by
using an anti-static wrist strap.
4. Locate and record your WD hard drive serial
number, model number, and date code on the
label on top of your drive.
5. Power off the computer and unplug the power
cord.
6. Remove the system cover (refer to your system
manual for instructions).
Kit Contents
WD Hard Drive
Documentation
Mounting screws
SATA cable
*Important: The 2.5-inch WD VelociRaptor is
enclosed in a 3.5-inch mounting frame heat sink that
maintains drive temperature. Disassembling these
components will void the warranty.
1