Wilson Manifolds 462259 5.9 Dodge/Cummins Performance Kit - Manual (Page 12)

12
18) Remove the hold down bracket for # 2 injector line. The original bracket will be replaced by
the new bracket supplied in the installation hardware kit. Re-assemble # 2 injector line with the
new bracket. Notice that the new bracket is oriented to the left versus the right. The oblong bolt
hole will be used to center the bracket. This bracket will mount on top of the manifold and
should be left a bit loose to facilitate alignment. The last mounting bolt on the manifold
towards the rear shares the same mounting hole and #2 injector line. Install the injector line at
this time and torque to spec. Do not bolt the bracket down at this time.
19) From the original intake horn, remove the stud for the wiring harness using the 10mm
socket. Re-install this stud on the cast Wilson elbow.