Wood’s Powr-Grip MT10FS10TAC - Manual (Page 9)

Rev 25.0/9-13 7 MT-HV11AC: #35089
4) Connect the power cable from the pump assembly to the power source as follows: Wire the
female connector provided to an appropriate current-protected power source (see serial
number plate for power requirements).
WARNING: Wiring must be done by qualified personnel, taking all appropriate
safety precautions.
The power source must be equipped with a ground fault circuit interrupter, in order to reduce
the risk of electrical shocks.
WARNING: Power source must be equipped with ground fault circuit interrupter.
Make certain the power cable is routed so that it does not become tangled while operating
the lifter or hoisting equipment. Then push the power cable’s male connector into the female
connector and twist to secure them together. Now the lifter is operational.
5) Perform Operational and Load Tests for the lifter as directed in MAINTENANCE: T
ESTING
S
CHEDULE
.
PUMP ASSEMBLY MOUNTING OPTIONS
BRIDGE CRANE MOUNTING JIB CRANE MOUNTING
<-- location location -->
<-- location