Working hints for your circular saw – WORX WU434.1 1500W 190mm Circular Saw 240V User Manual

Page 12

Advertising
background image

12

Working hints for your circular

saw

If your power tool becomes too hot, please run your circular saw
no load for 2-3 minutes to cool the motor. Avoid prolonged usage at
very low speeds.
Protect saw blades against impact and shock. Excessive feed
significantly reduces the performance capability of the machine
and reduces the service life of the saw blade. Sawing performance
and cutting quality depend essentially on the condition and the
tooth count of the saw blade. Therefore, use only sharp saw blades
that are suited for the material to be worked.
Choice of blades: 24 teeth for general work, approx. 40 teeth
for finer cuts, more than 40 teeth for very fine cuts into delicate
surfaces.

PaRallel GUiDe (See fig. e)
The parallel guide (8) enables exact cuts along a workpiece edge
and cutting strips of the same dimension.

Bevel cUtS (See fig. f)
Set required bevel angle between 0° and 56°. Do not use the depth
of cut scale when making bevel cuts due to possible inaccuracy.

Pocket cUttiNG (Soft MateRialS oNly)
(See fig. G1 aND G2)
This operation requires much skill with a saw and must only be
carried out by a competent person.

Warning: The blade teeth are exposed during this operation

1

2

3

8

F

E

G2

G1

Advertising