WORX WU743 230mm 2000W Angle Grinder 240V - Manual (Page 13)

13
the coded groove on the spindle collar of the machine head and
rotate to the required position (working position).
The closed side of the protection guard (10/14) must always
point to the operator.
Tighten clamping screw (11).
Operation
STARTINg OPERATION
Your switch is locked off to prevent accidental starting. To switch
on your tool, push the safety switch lever (B) forward and depress
on/off switch (A) fully. Now your tool is switch on. To switch off
your tool, just release the On/Off switch.
If you wish to use the tool continuously, push the safety switch
lever (B) forward and depress on/off switch (A) fully, then push
the safety switch lever (B) forward again and release the On/Off
switch. Now your switch has been locked on for continuously use.
To switch off your tool, simply depress On/Off switch fully, the
safety On/Off switch will automatically release.(See Fig. D)
Restarting protection
The restarting protection feature prevents uncontrolled restarting of
the machine after an interruption in the power supply.
To restart the operation, switch the On/Off switch (A) to the Off
position and start the machine again.
SOFT START MOTOR
Internal electronic components allow the motor speed to increase
slowly, which reduces the“twisting”effect on your wrists due to
the high power motor.
b A
D