X-1 (H2O Audio) iN3-5A3 - Manual (Page 3)

2.
3.
4.
4. Ensure the T-Seal is seated properly in all four
corners of the Cases Contact Surface.
3. To install a new or clean T-Seal, start at any
corner, push the T-Seal into the corner and run
your finger along the T-Seal pushing it into the
Case Contact Surface.
2. Starting at any corner, gently remove the T-seal.
(Do not stretch or pull on T-Seal)
1. Unlatch and open case.
How to install / replace the T-Seal
The most important feature of your H2O Audio
Waterproof Case is the removable T-Seal.
The removable T-Seal is the main barrier between the
harmful water and your iPod.
It is extremely important that special attention is paid to
ensure the T-Seal is seated completely in all four corners
and the Cases Contact Surface. If the T-Seal is dirty, out of
alignment, twisted or pinched in any way it will
compromise the integrity of the case and should not be
used.
H2O Audio has provided an extra T-Seal (included) in the
event of annual replacement, accidental damage, loss,
overexposure to direct sunlight, or if the T-Seal has become
misshaped though misuse.
Removable T-Seal Instructions