BenQ PB8260 - Manual (Page 44)

Maintenance 40
• Do not reset if the lamp is not replaced as this could cause damage.
Step 9. Reset the lamp counter
1. Press and hold Exit on the
projector for 3 seconds to display
the total used lamp time.
2. Press Menu on the projector or on
the remote control to access the
lamp hour timer. An adjustment
message will appear.
3. Press W or X to reset lamp hours
and press EXIT to leave.
Temperature warning light
When the Temperature warning light is on, it is warning you of the following possible
problems:
1. The internal temperature is too high.
2. Dust filters are clogged.
3. The fans are not working.
Turn the projector off, check that the dust filters are clean. If the problem persists, contact
qualified service personnel for further help.
For more detailed information, please refer to the following section.
Indicators
Illustration - table legend.
1.
Blank - : Light OFF
2. : Light flashing
3. : Light ON
4.
O
: Orange light
5.
R
: Red light
6.
G
: Green light