Yamato Scientific WR600S AutoPure - Manual (Page 12)

Alarm displays
DISPLAYS STATUS of the SYSTEM
CARTRIDGE OUT
The Autopure WR600 has stopped operating because either the QUANTUM or Q-Gard
purification pack is loose.
See the QUANTUM and Q-Gard installation section for more information.
NO FEED WATER
The Autopure WR600 system is connected to a reservoir level sensor and has detected
that the reservoir is empty.
Wait until there is water in the reservoir.
SYSTEM ERROR #
Indication of a specific fault or malfunction with an internal component of the system.
See the MAINTENANCE chapter for more information.
RS 232 ERROR
There is a problem with or service is needed for the RS 232 output.
See the MAINTENANCE chapter for more information.
A10 ERROR #
Service or maintenance needed for the A10 TOC accessory.
See the MAINTENANCE chapter for more information.
NOTE: The ALARM LED will blink while the ALARM messages are displayed on the LCD.