B&K ST260 - Manual (Page 14)

Page 12
)LJXUH.
)LJXUH/
)LJXUH0
Bridged application (High voltage)
The ST260 may be bridged to drive a high impedance speaker. To use, place the
source group jumper for both channels on the ‘L BUS’ jumper terminal. Place the
volume group jumper for both channels on the ‘NO VOL’ jumper terminal. Place the
jumper module on the ‘-L’ terminal.
Finally, connect the speakers (+) to the right channels (+) terminal and the speakers (-)
to the left channels (+) terminal. Input your source signal into the left channel input
(
only the left channel may be used for bridging ).
Note: The default position for this jumper plug is set to the ‘+L’ terminal. The jumper plug must be
installed at this location at all times when not using the ‘-L’ (invert) function.