Bakers Pride GDCO-G - Manual (Page 9)

9
Motor
Blower
Wheel
Set Screw (2)
Wheel Puller
Bolt 3/8” Hex
Item 1
Item 2
Item 3
E3770A
E3771A
3/8”-16 Bolt
1. Attach two item 2 to two
item 1 using item 3, 4 and 5.
2. Attach two item 7 to two
item 1 using item 3, 4 and 5.
3. U s i n g p r o p e r l i f t i n g
equipment attach item 1 to
the corresponding hole
patterns located in the
bottom of the oven with
item 6.
1 21796810 Weldment, Oven Leg
2 8633102 Caster, 5” Swivel W/Top Plate
3 8227700 Hex Hd 5/16-18 X ¾ Bolt #5 Zn
4 8509300 Washer, Flat SAE, 5/16
5 8435000 Hex-nut 5/16-18
6 82447-00 Hex Hd. 3/8-16 X .750 #5
7 8633101 Caster, 5" Swivel W/Plate & Brake
With Plate Caster
LEG ASSEMBLY INSTRUCTIONS - MODEL:BCO-E & GDCO-E
1 21796810 Weldment, Oven Leg
2 8633515 Foot Insert, Adjustable
3 8227700 Hex Hd 5/16-18 X 3/4 Bolt #5 Zn
4 8509300 Washer, Flat, SAE, 5/16
5 8435000 Hex-Nut 5/16-18
6 82447-00 Hex Hd. 3/8-16 X .750 #5
1. Attach four item 2 to four
item 1 using item3, 4 & 5.
2. Using proper lifting
equipment attach i t e m 1
to the corresponding hole
patterns located i n t h e
bottom of the oven with
item 6.
Without Plate Caster
Item P/N Description Item P/N Description
Figure 4
Figure 3 STACKING INSTRUCTIONS FOR: BCO-G & GDCO-G CONVECTION OVENS CLEANING THE BLOWER WHEEL Figure 2
Attach part # 21818062 with 6
each 8-32 stainless screws
Material: 14 ga201 Stainless
Remove the outer and inner flue from the
bottom oven before placing the top oven (to
prevent damaging the bottom oven’s flue). Re-
install after top oven is positioned.
2
1
3
22 1
77
6
44 3 55 4
66 5
33 2
22
1
77
6
44 3 55 4
66 5
88 7