Bolens BL50 - Manual (Page 8)

8
CONNECTING THE CORD
Use the cord hook when connecting the extension cord to the
power cord outlet. This helps prevent any disconnection.
1. Make a narrow loop with the extension cord.
2. Push the loop through the opening and move it onto the
hook on the motor housing (Fig. 5).
3. Plug the cord properly into the socket.
Only use outdoor-approved extension cords. Cord sets are
specified in the Important Safety Information section.
STARTING/STOPPING INSTRUCTIONS
Once the unit is plugged in, stand in the operating position
(Fig. 7). Squeeze the trigger to start the unit. To stop the unit,
release the trigger (Fig. 6).
WARNING: Always wear eye, hearing, foot and
body protection to reduce the risk of injury
when operating this unit.
HOLDING THE UNIT
Before operating the unit, stand in the operating position
(Fig. 7). Check for the following:
• The operator is wearing eye protection and proper clothing
• With a slightly-bent right arm, the operator’s hand is
holding the shaft grip
• The operator’s left arm is straight, the left hand holding
the D-handle
• The unit is at waist level
• The cutting attachment is parallel to the ground and eas-
ily contacts the grass without the need to bend over
Trigger
ADJUSTING TRIMMING LINE LENGTH
The Bump Head™ cutting attachment allows you to release
trimming line without stopping the motor. To release more line,
lightly tap the cutting attachment on the ground (Fig. 8) while
operating the trimmer at high speed.
NOTE: Always keep the trimming line fully extended.
Line release becomes more difficult as cutting
line becomes shorter
Each time the head is bumped, about 1 inch (25.4 mm) of
trimming line releases. A blade in the cutting attachment
shield will cut the line to the proper length if any excess line
is released.
Fig. 7
Fig. 6
Fig. 5
WARNING: Always wear eye, hearing, foot and
body protection to reduce the risk of injury
when operating this unit.
OPERATING INSTRUCTIONS