Belkin F1U109 User Manual
Page 4
4
4.
The program will begin installing at this point.
The first screen you will see is the following:
•
Select “F1U109” because that is the
autoswitch that you have.
•
Select which LPT port you installing the
AutoSwitch on. Normally, it is always
LPT1.
•
Click continue when done.
5.
The install program will then ask you for the
location of the install files. Because your floppy
drive is “A:”, just click OK.
6.
When done, the program will display the following message:
Click OK, and installation is complete!
7.
Next, you will see a box with the following
instructions. Click OK.
8.
Reboot your computer. THIS IS A VERY
IMPORTANT STEP!!! YOU MUST REBOOT,
OTHERWISE, THE SOFTWARE WILL NOT
INITIALIZE, AND YOU CANNOT CONTINUE
PROPERLY. Do this by clicking on START, SHUT
DOWN, and RESTART.