BOXLIGHT MP-25t - Manual (Page 41)

– 41 –
17. Another dialog box “PC ADJUSTMENT DISPLAY 2” will appear and the parameter data for the Mode you have selected
is shown in this dialog box.
18. Move the arrow to an item that you want to adjust by pressing the POINT UP/DOWN BUTTON(s).
19. To increase the level, point the arrow to ▲ and then press the SELECT (REAR CLICK) BUTTON. To decrease the
level, point the arrow to
▼
and then press the SELECT (REAR CLICK) BUTTON.
20. If you want to store the settings in the memory, move the arrow to Stored and press the SELECT (REAR CLICK)
BUTTON. When you have stored the settings, “OK ?” is displayed for confirmation. Move the arrow to Yes and then
press the SELECT (REAR CLICK) BUTTON .
21. To recall the parameter data before setting, move the arrow to Reset and then press the SELECT (REAR CLICK)
BUTTON. When you have reset the settings, “OK ?” is displayed for confirmation. Move the arrow to Yes and then
press the SELECT (REAR CLICK) BUTTON . You can adjust the settings again if needed.
22. To quit the MENU, move the arrow to Quit and then press the SELECT (REAR CLICK) BUTTON.
23. If you quit the MENU without storing the settings in the memory, the parameter data you changed will not be kept.
24. The stored settings are permanently held even if the MAIN ON/OFF is switched off.
ITEM
CLAMP
DISPLAY AREA
HORIZ. SCALE
FUNCTION
Adjustment of the clamp level. When the image has a dark bar, try this adjustment.
Adjustment the display area to match your PC.
Expanding or compressing level for the horizontal direction.
VERT. SCALE Expanding or compressing level for the vertical direction.
MAIN MENU DISPLAY
Adjust the display area, move the arrow
by pressing the POINT UP/DOWN
BUTTON(s) to select (
s ) and press the
SELECT (REAR CLICK) BUTTON.
Another dialog box “DISPLAY AREA
DISPLAY” will appear.
Move the arrow to an item that you want
to select display area by pressing the
POINT UP/DOWN BUTTON(s) and press
the SELECT (REAR CLICK) BUTTON.
Selected mode data will be displayed in
H, V box.
To close dialog, move the arrow to “Quit”
and press the SELECT (REAR CLICK)
BUTTON.
PC ADJUSTMENT
DISPLAY 2