AJA FS2 Manual - Manual (Page 18)

FS2 v2.1r1 www.aja.com 18
• Video Processor Input Source and Background Fill selections
• Video Processor Output Format and Mode
• Loss of Input
• Video Processor Up, Down, Aspect, Edge, and Custom Conversions
• Video Processor Matte Adjustments
• Video Processor H and V timing
• Video Processor Proc Amp, Color Corrector, and Legalizer
• AFD embedding, input scan format (i or p), and caption translation
• Video Processor Test Patterns
• Freeze Output
AUDIO 1 and 2 Displays the Audio 1 Menu Group, which allows you to set Audio Processor 1 selections
and adjustments:
• Audio Processor input selection, output embedding, and Audio Follow Video (AFV)
• Audio Signal Generator Selection
• Audio1 channel and stereo mapping
• Audio1 level, phase, and delay adjustments
Control Knobs
These are the general rules of SELECT and ADJUST knob operation:
SELECT Turning the SELECT knob performs these actions:
• Turn SELECT in either direction to scroll through the menus.
• Stop on a menu to enter that menu for editing.
• Turn SELECT within a menu to scroll through multiple parameters.
• Pause on a parameter to select it for editing. For multiple fields in a parameter, use
SELECT to move through the fields (after pressing Adjust to enter field editing mode).
• Push SELECT momentarily to undo and restore the previous setting.
ADJUST Turning the ADJUST knob performs these actions:
• Turn ADJUST to change the values of a selected parameter.
• In most cases, leaving a value in place for a moment sets that value.
• To perform special actions, such as recalling a register, push the knob to confirm the
displayed value. Display line 4 indicates such special actions.
• Some parameters having multiple fields, such as IP Address require you to push the
ADJUST knob to select a field, and push again to save changes.
• Hold down the knob to reset a value to the factory default; for multiple field values, all
fields are reset to the default.