AJA FS1 Version 2.2.2.1 - Manual (Page 79)

1
69 FS1 Installation and Operation Manual — 51.1 SNMP Enable
51.1 SNMP Enable
This parameter turns ON and OFF all SNMP messaging between the FS1 and an external
client. Refer to Chapter 6 for a description of SNMP and how the FS1 supports it. When
SNMP is enabled, one or more of 4 alarms may be sent by the FS1 as a trap message:
• Power supply failure or disconnection: fs1PSAlarm (see parameter 60.1)
• Reference video: fs1REFAlarm (see parameter 60.3)
• Format: fs1FMTAlarm (see parameter 60.2)
• Temperature of FS1 is over limit (internally): fs1OVRAlarm
Note: With SNMP parameters 51.1 through 51.6, there is no timeout when editing—
changes made while in these menus will be saved and activated when the menu is
exited. For example, changing from Disable to Enable 1 does not turn SNMP on. You
must exit the 51.1 SNMP Enable parameter menu in order to turn SNMP on.
51.2 SNMP Trap Destination 1
This parameter determines the SNMP Trap Destination IP address where trap messages
issued by the FS1 will be sent.
When the SNMP Trap Destination IP addresses are edited, you can abort the editing
process by backing out (press the Select down arrow button repeatedly until the edit
passes the first octet). You’ll notice that after completing the edit on the last octet, the
display will blink—this is an indication that the edited IP address is about to be saved.
You can save the edited IP address by pressing the Select up arrow to save or choose
not to save by pressing the Select down arrow button.
51.1 SNMP Enable Description of Choices
Parameter Adjustments:
Disable (Default)
Enable 1
Enable Both
When set to Disable, the FS1 will not issue SNMP trap messages.
When set to Enable 1, the FS1 issues SNMP trap messages to Trap Destination 1
(parameter 51.2) and as defined in the MIB.
When set to Enable Both, the FS1 issues SNMP trap messages to Trap Destination
1 and 2 (parameters 51.2 and 51.4) and as defined in the MIB.
51.2 SNMP Trap Dest 1 Description of Choices
Parameter Adjustments:
variable Using the Adjust buttons, enter the IP address of the destination where SNMP
command messages (called “traps”) will be sent. This is usually an SNMP client
somewhere on your LAN.
Default: 192.168.0.3