AJA HDP2 - Manual (Page 12)

12
HDMI Channel—Choose Auto, 2-channel or 8-channel embedded audio. Choosing
“Auto” lets the HDP2 automatically select the audio channels based on the
attached device's capabilities.
Note: When in 2-channel mode, the audio pair
selected will be the same as described by the “Analog Audio” selection, below.
Analog Channel—Choose which 2 embedded audio channels are routed to the RCA
output pair: Ch 1+2, Ch 3+4, Ch 5+6, or Ch 7+8.
Update Tab Screen Use this Update screen to view the software version currently installed on the HDP2
or install new software.
Mini Config, Update Screen
Note: When discussing Mini-Converters, “Firmware” is software that will be stored
in the Mini-Converter’s non-volatile memory and used when it is powered up. This is
something different than the Mini Config application software. The version numbers
shown in the Update screen refer only to the firmware.
The following fields and control are present in this screen:
Installed—this field shows the version of the firmware currently installed inside the
Mini-Converter.
Desired—this field shows the version of firmware embedded in the Mini-Config
application which you can install into the Mini-Converter by clicking the
Update button.
Update —this button initiates a software update operation loading the “Desired”
version of firmware into the Mini-Converter’s non-volatile memory.
Progress—this indicator bar shows the progress of software being installed.