Ambient Tiny Lockit - ACN TL - Manual (Page 16)

14 www.ambient.de
TC > Level
Select Level to adjust output level on Lemo/TC.
The adjustable range is from -45 dB to 0 dB. Default
level is 0 dB. This equals 3 Vpp without load or 1,5 Vpp
or 0 dBu into 1 K Ohm.
Select by toggling left / right, select by pushing in
the config switch.
SYS MENU
The SYS menu serves to configure various parameters,
in this release version the display behavior and the
BNC sync signal impedance are set. Push the config
switch to enter.
SYS>CONFIG
Enter the configuration by pushing in the config switch
Navigate to DISPLAY, Lemo/ACN or BAT, push the
config switch to select.
SYS>CONFIG>DISPLAY
Adjust display brightness from 1 to 10 toggling the
config switch left/right. Push in to select value.
The curser will jump to the Auto-off settings:
Select after what time the display shuts off after
entering the main operation display.
Choices are:
Never – 5 seconds – 30 seconds – 1 minute – 5
minutes.
Select by toggling the config switch left/right. Push in to select value.