Front panel, Rear panel, ᕃᕄ ᕅ ᕆ – BBE DS48 User Manual
Page 9
3
FRONT PANEL
1. Power Jack
This accepts a standard IEC type AC bayonet plug. Because the unit uses universal
switching power supply, no voltage selection is required. The ON/OFF power switch is also
located here.
2. RS232 Interface
Connect this to the serial port on a PC using the included cable or other standard DB-9
type cable. With the software installed, the PC can now monitor and program the DS48.
3. XLR Outputs 1-8
These are balanced (Pin 2 Hot) XLR outputs.
4. XLR Inputs A-D
These are balanced (Pin 2 Hot) XLR inputs that accept the signal from the outputs of the
mixer.
ᕃ
ᕄ
ᕅ
ᕆ
11. Output Meters
These display the levels of the eight output channels. The seven LED lamps per display
are in 6 dB steps from –30dbV to –6dBV, then -3dBV, then Limit (0dBV), then Clip (+8 dBV)
12. Output Mute Buttons
Pressing one of these buttons will mute the respective Output channel and the LED will
illuminate. All outputs will mute automatically during certain program selection and edit-
ing processes, to protect the loudspeakers
REAR PANEL