BLACKHAWK! PORTO-POWER B65115 - Manual (Page 2)

Figure 1 - Pump and Ram Components
Dust Cover
Oil Filler
Screw
Handle
Release Valve
Plunger
Hose
Hose
Coupler
Ram Coupler
Ram
SAFETY and GENERAL INFORMATION
Save these instructions. For your safety, read and understand the information contained within. The owner and
operator shall have an understanding of this product and safe operating procedures before attempting to use this
product. Instructions and Safety information shall be conveyed in the operators native language before use of this
product is authorized. Make certain that the operator thoroughly understands the inherent dangers associated with
the use and misuse of the product. If any doubt exists as to the safe and proper use of this product as outlined in
this factory authorized manual, remove from service.
Inspect before each use. Do not use if broken, bent, cracked or otherwise damaged parts are noted. If any
component of this product has been or suspected to have been subjected to a shock load (a load dropped suddenly,
unexpectedly upon it), discontinue use until checked out by an Porto-Power Blackhawk Automotive authorized
service center. Owners and operators of this equipment shall be aware that the use and subsequent repair of this
equipment may require special training and knowledge. It is recommended that an annual inspection be done by
qualified personnel and that any missing or damaged parts, decals, warning/safety labels or signs be replaced with
factory authorized replacement parts only. Any component of this Porto-Power Kit that appears to be damaged in
any way, is worn or operates abnormally shall be removed from service immediately until such time as it can be
repaired/replaced. Labels and Operator's Manuals are available from manufacturer.
PRODUCT DESCRIPTION
Porto-Power Kits are designed to be used for pushing, spreading, and pressing of vehicle body panels as well as
various component parts and assemblies. A variety of attachments are included. B65114 is rated at 8,000 PSI;
B65115 is rated at 10,000 PSI. Rams are rated from 4 to 10 tons respectively.
WARNING: To reduce the risk of personal injury and/or property damage, ensure that the rated working
pressure of each pressurized attachment be equal to or greater than the rated working pressure developed
by the hydraulic pump.
Always check connections before using. Alteration of these products is strictly prohibited. Use only those
adapters and attachments provided and approved by the manufacturer.
Note: when extension tubes and/or offset attachments are used, the rated capacity is always reduced by 50% for
each tube or offset attachment connected. See Parts Section for identification of “offset” attachments.
2
!
!