AudioEngine D2 24-BIT WIRELESS DAC - Manual (Page 6)

D2 setup guide 8 9
Pairing
Pairing is the function by which two devices become acquainted. Once
a Sender and Receiver(s) are paired, they will remember one another.
Note: D2 Senders and Receivers packaged together are paired out
of the box, so if you’re only using one Sender/Receiver set, no further
configuration is needed.
To pair an additional Receiver or to re-pair a Sender/Receiver set, press
the Pair button on the Receiver (the Pair LED will blink), then press the
Pair button on the Sender. Both Sender and Receiver pair lights should
now be solid, indicating that they are paired.
Troubleshooting
• I have connected my D2 Sender and Receiver as shown, but there is
no music output.
1. Check to see that the Power and Pair lights are lit and solid. If
not, try another USB port on your computer.
2. If the Pair light is blinking re-pair the Sender and Receiver as
discussed in the Pairing section.
3. Verify that “Audioengine D2” is selected as your output device
under Control Panel (PC) or System Preferences/Audio (Mac).
4. Try another USB cable.
5. Verify that the proper input source is selected on your audio
system.
• I have connected my D2 to my TV/DVD/BluRay, but there is no sound
output.
1. Verify that the D2 Sender and Receiver are both connected to a
power adapter and that the power lights are lit.
2. Be sure that your source digital audio is set to “PCM Stereo”.
• Only one channel plays through my D2.
1. Check the RCA cables between your D2 and your sound system.
2. Check your audio player to ensure that the balance is centered.
Break-In Period
Your DAC will sound great out of the box and will get better over time.
However, give it 40 to 50 hours break-in time before doing any critical
listening.
Specifications
Electrical
Full Scale Output
2.0V RMS
Frequency Response 10 Hz - 30 kHz, +/- 0.5db
S/N Ratio (DC to 20 kHz) >115 dB
THD+N (1 kHz FS 96 kS/s) <0.0015%
Interface
Input Data Rate
up to 192KS/s
Input Bit Depth up to 24 bits
USB type 1.1 or above
Wireless Range (typical) >100 ft
Power Requirements
Sender 270ma
Receiver 300ma
For additional specifications and product information go to:
audioengineusa.com