Bang & Olufsen BeoVision Avant - Technical Sound Guide - Manual (Page 20)

20
Setup: Sound: Speaker Groups: PRESETNAME: Advanced Settings: Bass Management: Enable Filtering
Selecting this menu brings you to the
menu where you determine whether the
Bass Management filtering is on or off
for individual output channels. When this parameter is set to ON for a
given loudspeaker, this means that its
low frequency content will be re-
directed to another loudspeaker in the
Speaker Group.
Setup: Sound: Speaker Groups: PRESETNAME: Advanced Settings: Bass Management: Panning
Selecting this menu brings you to the
menu where you adjust the left/right
panning of the Bass Management signal
derived from each output channel into
the two Bass Management low-
frequency channels.
Setup: Sound: Speaker Groups: PRESETNAME: Advanced Settings: Bass Management: Re-Direction
Levels
Selecting this menu brings you to the
menu where you adjust the level of the
two Bass Management low-frequency
channels being added back to the
individual output channels.
Setup: Sound: Speaker Groups: PRESETNAME: Advanced Settings: Subwoofer: Time Alignment
The Time Alignment setting allows you
to adjust the relative delays of the
subwoofer(s) and the main loudspeaker
channels. When this value is positive,
then the subwoofer is delayed relative
to the main loudspeaker channels. When
the value is negative, then the
subwoofer output precedes the main
loudspeaker channels by the displayed
value.
This may be useful, for example, when a
wireless subwoofer is used and it is
necessary to delay all main loudspeakers
in the Speaker Group to wait for the
transmission time of the wireless
connection to the subwoofer.
Note that the small differences in
latency between various Bang & Olufsen
loudspeakers, connected either
wirelessly or with Power Link cables, are
automatically compensated for
internally in the system.
Range: -30 ms to 30 ms.
Step size: 1 ms.