BT Studio 3500 - Manual (Page 47)

BT Studio 3500 – Issue 1 – Edition 2.1 –02.04.07 – 7999
If you experience any problems, please call the Helpline on 0870 605 8047 or email [email protected]
Up to 5 handsets can be registered and operated from the BT
Studio 3500 base.
Each handset can be registered with up to four bases.
If you buy new handsets to use with your BT Studio 3500
they will have to be registered to the base before you can
use them.
Register a new BT Studio 3500 handset to your BT Studio
3500 base
1. At the base: Press and hold for 3 seconds until
you hear two beeps. You now have 90 seconds to register the
handset.
2. At the handset: Press , scroll to
REGISTER
and
press .
3. Scroll to REG BASE and press .
4. Enter the base number (1–4). The numbers flashing are
already in use.
5. The display will show SEARCHING...1 When the handset finds
the base signal, the SEARCHING and base identification
number is displayed.
6. The display will ask for the PIN to be entered. Enter the PIN
(the default setting: 0000) and press to confirm. You will
hear a beep. The handset is now registered.
IMPORTANT
Before registration, make sure the
handset batteries are fully charged
and that you are close to the base.
Please note
Handsets that were supplied with
your BT Studio 3500 base are already
registered to it as HS-1, HS-2 etc.
Each additional handset you buy must
be registered with the base.
Additional handsets and bases
47
8474 Studio 3500 UG Iss2 [2] 25/10/07 16:37 Page 47