Bang & Olufsen BeoSound 3200 - User Guide - Manual (Page 40)

40
If you already have a Beo4 remote
control, it is possible to reconfigure it
for use with your music system.
You can also add extra ‘buttons’ to
Beo4 which can then be called up by
pressing the LIST button. You can
rearrange the order in which the
extra ‘buttons’, that you yourself
have added and the ones that were
already present, appear when you
press LIST.
When you add a ‘button’, you can choose
where to place it in the list of extra
‘buttons’ in Beo4. Extra ‘buttons’ can also
be deleted again.
Customise Beo4
Configure Beo4
Press and hold the standby
button down
Press to get access to the Beo4
setup function
Now, let go of both buttons.
ADD? appears in the display
Press repeatedly until CONFIG?
appears in the display
Press to be able to select the
type of configuration
Press repeatedly until AUDIO?
appears in the display
Press to get access to the audio
configuration
Press repeatedly until AUDIO1
appears in the display*
Press to store the configuration
STORED appears to indicate that
the configuration has been
stored. You leave the Beo4 setup
function automatically
*If the audio configuration does not contain
AUDIO1, select BASIC instead.
•
LIST
ADD?
LIST
CONFIG?
GO
LIST
AUDIO?
GO
LIST
AUDIO1
GO
STORED
•
LIST
ADD?
GO
▲
▼
GO
1 – 9
ADDED
Add an extra ‘button’
Press and hold the standby
button down
Press to get access to the Beo4
setup function
Now, let go of both buttons.
ADD? appears in the display
Press to call up the list of
available ‘buttons’ to add from.
The first ‘button’ appears in the
display, it flashes on and off
Press to move forwards or
backwards in the list of all extra
‘buttons’
Press to add and place the
‘button’ on its preset position or
as the first ‘button’ in the list,
or…
Press to insert the ‘button’ at a
specific position in the list
ADDED appears to indicate that
the ‘button’ has been added,
and you leave the Beo4 setup
function automatically